I had seen a similar necklace months ago and kept the photo because I knew I wanted to make something similar for someone one day. Verity was that someone! As I was rifling through my stones to find something she would like (she likes pastel colours), I stumbled upon a purply rose quartz. I set it aside while I looked at other stones, but I kept going back to the rose quartz. I decided that it was a sign that the stone was meant for her!

To make the necklace: I made the vessel for the stone which consisted of melting silver and rolling out a piece wide enough to be the walls around the stone and a flat piece for the bottom big enough for the stone and vessel walls, then soldering it together, cleaning it up, soldering the jump rings to it and the 4-claw setting for the cubic (which was from another earring she had), soldering the chain to the jump rings, polishing the whole thing, setting the stones, and lastly polishing everything again.

Really happy that I finally got to make this necklace!

Stackable White Gold and Diamond Rings

These rings may seem simple but let me tell you, when there are infinite possibilities in stackable ring designs, it’s hard to pick just a couple!

I started by swapping Shannon’s yellow gold for white gold since she prefers white and didn’t have enough. I was able to use one of the pre-existing settings (princess cut - square centre stone) from a pendant she had for the thinner ring. Once both bands were made and I soldered the princess setting to the thinner ring, I sent them off to the stone setter!

With all the materials Shannon had left over she actually ordered a third ring which will balance the other two rings nicely. I’ll post a photo of it when it’s done!